First I used the polygon lasso tool to all of the wood items that I needed and started out with the center beam - chopped it out and duplicated it - then merged it together and adjusted it using free form a bit and clone tool - used these for the Steps
step 2 of 15
Next I chopped out the corner piece of the wood to use for panels for the outside of the house. Again making a copy and adjusting to get as close as possible to straight then merged them and stretched up and down to look like a wood panel - duplicated a bunch of times to fit in to the house
step 3 of 15
Chopped out the edge of another wood part of the pillar smooth and used it for the front porch overhang - Again duplicating and adjusting - merging and - duplicating to get the front of the porch
step 4 of 15
I started out using a plain piece of the wood from the edge and set it to the roof over hang
step 5 of 15
Once I had the edges in place I added a nice piece of the engraved piece to the center and then once I had it where it looked ok - I then went into my Filter area - thus choosing the Vanishing point tool to blend the Engraved part in to the plain end areas that were there - with a tad of burning
step 6 of 15
I chopped out a small piece of the basket weaving from the ceiling and duplicated it for window curtains
step 7 of 15
The duplicated plain piece for the window at the start
step 8 of 15
Each side for a portion to make the window as well as the door
step 9 of 15
Here are the slated areas of the plain wood for the outside boards
step 10 of 15
And here are the basket weaving's for the windows
step 11 of 15
Here was the first portion of the house when merged without the curtains
step 12 of 15
Here I burned the window dressing a bit and was added in
step 13 of 15
Here is my picture I took when hiking
step 14 of 15
Then I added over top of the black background area my hiking picture and just added in a motion blur to the bottom of the picture and used invert for the greenish color and just used the Rectangular Marquee tool to chop out the areas for the doors and windows area to show them as black.
step 15 of 15
Here are the parts I chopped from that are my general source areas that were used for the house - then once all was done I also used a bit of burn tool to the house.
Enjoy ;)