I masked out a portin of the source image to work with....
step 2 of 11
I kept the near original shape to place around the eye of the female model which will appear in a later step....i waped slightly to conform to the shape of the model's face.
step 3 of 11
I erased a portion of the shape i had already cut out, and stetched it, and placed over each shoulder....then i layered those shapes a few times.
step 4 of 11
i cut out a few pieces from this picture of my boyfriend's harley, and used them to create the mask and eye piece....
step 5 of 11
the mask and eye piece...
step 6 of 11
and on the very bottom, i have this image i made on Bryce/DAZ Studio....(the model)
step 7 of 11
while on the very top i have this blurred out version with a light filter, and everything else is layered and blended in between.
step 8 of 11
I'm adding a SBS for the making of the Bryce/DAZ model....I started out with the basic Vic4 model (a freebie)....changed her skin tone and added hair....
step 9 of 11
I posed the model with a pre-made pose from a pose pack I downloaded from most-digital-creations.com, then zoomed in to go to work on her head and face. I repositioned the head....
step 10 of 11
I adjusted her eyes, rolling them upward, flexed the brows, added some pout to the lips; I played with her hair, until it appeared windy enough for me, and changed the color to purple.....then I transferred the figure back into Bryce, zoomed in and rotated the camera a bit, changed the sky to full black, ground to pewter metal wit hreflection, and adjusted the angle of the sun....
step 11 of 11
Coming up with a final render of this.....
I had to re-create the steps, so I did the best I could....hope this was helpful.