Cut out cross and place on arm. This is you cross layer.
step 3 of 8
Close cut cross - use pen tool.
step 4 of 8
go to filter - artistic - poster edges
step 5 of 8
This is what it should look like.
step 6 of 8
Duplicate poster edge layer and Gaussian blur and place below original poster edge layer.
step 7 of 8
go back to original poster edge layer and in the layers section change to overlay. It should look like this.
step 8 of 8
Place original poster edge layer above blur layer and use overlay mood in layer section and reduce opacity to 50%. The blur layer change to pin light mood in layer section and reduce opacity to 70%.