A Work in Progress: Stunt Plane



This guide was made for entry:
Stunt Plane
In Contest:
paper planes


step 1 of 12

Fold the upper corner down as shown. Then unfold it again so the paper is normal but with a crease.

Creation of Stunt Plane: Step 1

step 2 of 12

fold the other corner down

Creation of Stunt Plane: Step 2

step 3 of 12

when unfolded, the paper should have an "X" across it, as shown.

Creation of Stunt Plane: Step 3

step 4 of 12

push the two sides in and start to collapse the "X" while bringing the top down

Creation of Stunt Plane: Step 4

step 5 of 12

push down and run your finger along the creases. It should form a pointed, triangular top.

Creation of Stunt Plane: Step 5

step 6 of 12

fold the point down to where the tip meets the fold. make a crease

Creation of Stunt Plane: Step 6

step 7 of 12

Pull in the tips from both sides and insert them in the slot created by folding down the top. Make a crease

Creation of Stunt Plane: Step 7

step 8 of 12

If done correctly, the plane should look like this.

Creation of Stunt Plane: Step 8

step 9 of 12

Now, fold the entire plane in half and make a crease.

Creation of Stunt Plane: Step 9

step 10 of 12

Now, fold each side back down, leaving about a half inch. This will create a strip the length of the plane for you to hold as you throw it.

Creation of Stunt Plane: Step 10

step 11 of 12

When finished, it should look like this.

Creation of Stunt Plane: Step 11

step 12 of 12

Fold up a strip about a half inch at the edge of each wing. Finally, rip or cut flaps at the end of the wings. By adjusting these up and down you can make the plane do stunts. It should look like this when you're finished. Good Luck!

Creation of Stunt Plane: Step 12

Final result

Creation of Stunt Plane: Final Result

LOGIN or REGISTER FOR FREE
to rate this guide and create your own guides.

Votes


uservoted
greymval
friiskiwi
iquraishi
Score:
9.5