Got the Front and side profile image of the phone from the internet. and Box extrude the main body
step 2 of 10
Start working on the Center set of buttons.
step 3 of 10
work on the keypad. I made box then subdivide it into area for the keys .. then Extrude the Key grid. then adjust the final face so that it got that saw tooth effect that is on the real phone
step 4 of 10
Work on the Screen area. And UV Map the phone
step 5 of 10
Now I import the Modal from Hexagon into Carrara.. Set up the Light Test render.
I ended up scanning my phone on my flatbed for a Texture because I cannot find a High res Image of the phone. The stuff on inter net was to Low res making the Key pad look really bad at High res.
step 6 of 10
Since the Moderator asked for it. This is a photograph of my Phone. That I used To make the screen shot. Since I cannot fine anything on the Internet that is good enough quality at first.
step 7 of 10
This is an Extract of the Screen from the Last step. It was cleaned up and fixed some problem in Gimp.
step 8 of 10
This is the Scan of the Cell phone from my flat bed Scanner. Again because I cannot find any good quality image of the phone for the High Resolution Render.
step 9 of 10
I then composite and fix up the image to be used for the texture in Gimp
step 10 of 10
and here is the Xara Screen of the Texture.. I was surprised it was still there..